PART I--TURN YOUR INGREDIENTS INTO A BALL OF PUTTY[]
part ii--just add hot water, stir, add more water and make eco/kid friendly, non-toxic big (not giant) bubbles[]
Place the Putty ball in 1 cup (or 250ml) of water. Use at least a 2 cup Pyrex measuring cup
Full 1 liter amount. Best to be stored and kept in a plastic bag. Otherwise, like Play-Doh, it will eventually dry out.
Place in microwave oven along with the stir stick you are using.
Heat in micro for 1 1/2 minutes and remove then begin to stir
Place contents inside larger container and continue to sitr until the Putty ball is fully dissolved (1-2 minutes usually)
As you stir it will start foaming.....
Your pH should be within range since you have already added citric acid and baking soda. Important note: sometimes a little bit of the ingredients are lost in the batching of the Putty version of RAD, usually the Jlube is the only ingredient lost that is noticeable. If you are not getting good results after adjusting the pH add just a very tiny bit more JLube to make up for what may have been lost.
Stir in 3 more cups of room temperature water to make approx. 1 liter of putty juice. Skim off the extra foam if desired OR let set until it disappears.